Click here to print this page

To see the animated tutorial visit:



Do you want to level a steep slope on your property or enclose an area for a decorative garden? Building a concrete block retaining wall is easier than you may think.



Skill Level & Time to Complete

  • Beginner -  
  • Intermediate -
  • Advanced -
  - Curves require more blocks than straight runs.


Materials List
   Retaining Wall Blocks
   Landscape Fabric
   Gravel (optional)
Tools List
   3 lb. Drilling Hammer
   Carpenter's Level
   Mason's Line
   Flat-Pointed Shovel
   Hand Tamper
   Safety Glasses
   Back Support


1. Begin by measuring out your prospective wall, using stakes and mason’s line to mark off the key points. Or, you can use a garden hose to mark off the perimeter.
2. The key to a successful concrete block retaining wall is to start with a level foundation course of blocks. The foundation course must be below ground level so that the soil will hold it firmly in place. Starting at the lowest point, use a flat-pointed shovel to dig a trench. The dimensions of the trench will vary depending on the size of your block.
3. Tamp the trench with a hand tamper to compact the underlying soil.
4. If your property slopes, you may have to dig your foundation trench in a series of steps equal to the height of the blocks. Then, as you continue with construction, build up the lower sections with block until the stepped areas accept successive courses of blocks in a level wall.
5. Once you have a sound foundation trench, you can begin laying block, checking regularly for level. First pour a one inch layer of sand underneath the foundation course to provide a more solid base. The sand will make leveling easier and improves drainage.


6. Set the first block in place and tap it with the butt end of your drilling hammer if not level. If your property is relatively flat, continue laying the foundation course, making sure that all blocks are level with each other and below ground. If the ground slopes build up the lower sections with block.
7. Once the entire foundation course is installed, set one block in position at each end. The lip of each should fit against the back of the foundation course block. Check the level of the foundation course before you start the second course. If necessary, adjust the retaining wall blocks until the foundation course is completely level.
8. Cut one block in half for the start of the second course to ensure that the first and second courses are staggered. Set the rest of the second course blocks in place and then fill the trench around the foundation course with soil.
9. Continue placing blocks, making sure each course is staggered over the previous one.
10. To prevent the soil from seeping through the spaces between the blocks, line the cavity behind the wall with porous landscape fabric. Start at the base of the cavity and unroll the fabric until it overlaps the top course of block. Cut the fabric and continue along the length of the wall until the entire cavity is lined.


11. Backfill the cavity with soil. If the wall is 2 1/2' or higher, fill the area closest to the block with gravel. You should have gravel to a width of about 6" from the block. The rest of the cavity can be filled with soil. This will facilitate drainage.
12. Trim the excess landscape fabric. You can top off the terraces with decorative stone or mulch.
13. And there you have it…a decorative wall that will help define and accent your property. Your concrete block retaining wall is as aesthetically pleasing as it is useful.

Copyright© 2001-2006, Inc. All rights reserved.